1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

overprinting - need help

Discussion in 'Troubleshooting' started by BJS227, Jun 17, 2019.

  1. BJS227

    BJS227 Member

    Joined:
    Sep 19, 2017
    Messages:
    42
    Likes Received:
    7
    take a look at the pic. We have some, what i would call, overprinting. An recommendations on how to fix/improve this issue? In the past we have had clogging nozzles issues so i have increase the heat a little and it worked perfect and then just lately we have been getting this result. any ideas?

    20190617_194829534_iOS.jpg
     
    #1 BJS227, Jun 17, 2019
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    #2 WheresWaldo, Jun 17, 2019
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    If you have changed filament and this started happening around that time, you may need to recheck your temperatures as well. The guide @WheresWaldo has pointed you to is an excellent start, there are a couple of others you can use as well. Stringing can be from a variety of things, but heat and retraction are the big ones.

    http://reprap.org/wiki/Print_Troubleshooting_Pictorial_Guide
    and :
    http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide


    Here is a video on stringing too:

     
    #3 mark tomlinson, Jun 18, 2019
    tkoco likes this.

Share This Page