1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Part Identification

Discussion in 'Troubleshooting' started by Terry Reilley, Jan 27, 2017.

Thread Status:
Not open for further replies.
  1. Terry Reilley

    Terry Reilley Member

    Joined:
    Dec 21, 2015
    Messages:
    104
    Likes Received:
    20
    Hi everyone!

    Robo3D just sent me a replacement RAMPS board to solve my dead heat bed issue and during the disassembly of the old board, I discovered the problem. There is a green connector that attached to the RAMPS board and I would like to know what this connector is called and if I can get it on Amazon. I'd order it from Robo3D but their shipping is kinda slow with CES and me being on the East coast. I might as well get a couple extra while I'm at it. Rob sent the 4 connector version of this with the RAMPS board, but not the smaller ones like in the picture.

    You can see where a burn occurred, which explains the dead printer bed!

    WhatIsThis.png
     
    #1 Terry Reilley, Jan 27, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Jan 27, 2017
  3. Terry Reilley

    Terry Reilley Member

    Joined:
    Dec 21, 2015
    Messages:
    104
    Likes Received:
    20
    Mark, you are just too awesome. Thank you!!!
     
    #3 Terry Reilley, Jan 27, 2017
    Rigmarol and mark tomlinson like this.
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    I can never remember exactly what those connectors are called (and it ain't "molex") :)
     
    #4 mark tomlinson, Jan 27, 2017
  5. Terry Reilley

    Terry Reilley Member

    Joined:
    Dec 21, 2015
    Messages:
    104
    Likes Received:
    20
    Yeah, I tried that and found nuthin'.
     
    #5 Terry Reilley, Jan 27, 2017
Thread Status:
Not open for further replies.

Share This Page