1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Pla jamming

Discussion in 'Troubleshooting' started by BJS227, May 18, 2019.

  1. BJS227

    BJS227 Member

    Joined:
    Sep 19, 2017
    Messages:
    42
    Likes Received:
    7
    After printing great for awhile now. We have gone through 4 hot ends last week. After changing each we do a z offset, bed calibration and then a fine tune. After getting everything ready to go. The printer primes itself, and start in on the raft. After 2-3 layers which looks good the PLA jams in the extruder and the feed gear start to skip. There is plenty of z offset and by no means is it to close to the print. Also cleaned the spline gear and everything seem to not be binding. Any ideas how i can fix this?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338

Share This Page