1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

possible upgrade/modification to r1+

Discussion in 'Projects' started by gobblinfool, Jul 24, 2016.

  1. gobblinfool

    gobblinfool Member

    Joined:
    Apr 26, 2016
    Messages:
    71
    Likes Received:
    15
    hey everyone.. was thinking of the possibility of upgrading the z axis on my robo r1+ to be able to print taller pieces.. I believe I found the correct lead screws and support shafts online that are much longer.. I know I'd have to build a different frame to support the new rods and lengthen the wires.. but also looking for some suggestions or input on the matter.. I'd like to print out full forearm, bicep, shin pieces to my iron man suit.. I'm not much caring for having to glue 2 pieces together as it doesn't seem like they fit together perfectly.. any input is appreciated..

    Sent from my SM-G930V using Tapatalk
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,957
    Likes Received:
    7,344
    Search through the projects folder.
    Someone else did something very similar (extending the Z axis).

    Not recently so you may have to wander back through it a ways.
     
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339

Share This Page