1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Power supply

Discussion in 'Troubleshooting' started by Peter Joseph Rosado, Aug 30, 2018.

  1. Peter Joseph Rosado

    Peter Joseph Rosado New Member

    Joined:
    Jun 10, 2016
    Messages:
    16
    Likes Received:
    0
    Hello there,

    Have a question, I have a Robo 3D R1+ and the power supply seems to be giving out on me. I have another from another printer that in no longer working. However the power supply is working just fine. Question is that the power supply the the Robo 3D runs outputs 12v and 30a and the other one runs 24v and 16.5a is that too low to keep the printer up or do I have to replace with that exact voltage?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338

Share This Page