1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Print Popping off of Bed. Help Please

Discussion in 'Troubleshooting' started by Chris Pooley, Dec 15, 2016.

  1. Chris Pooley

    Chris Pooley New Member

    Joined:
    Sep 15, 2015
    Messages:
    11
    Likes Received:
    0
    Hi,
    When printing the first 50 or so layers stick perfectly, but after that it just seems to pop off and then just make a mess of everything, hard to get a complete print at the minute.
    Sometimes after about 5 layer the corners and ends start peeling up and warping, the whole bed has been hair sprayed but still doesn't stick?
    Any ideas?
    Thanks
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Share a picture of.your fist layer as well as print temps (hotend and bed). What material ?
     

Share This Page