1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Print Stuck

Discussion in 'Troubleshooting' started by VigilantWookie, Feb 21, 2020.

  1. VigilantWookie

    VigilantWookie New Member

    Joined:
    Feb 6, 2020
    Messages:
    12
    Likes Received:
    0
    My finished print is stuck on the print bed and I haven't been able to remove it yet. Suggestions?
     
  2. jscottb

    jscottb Member

    Joined:
    Sep 10, 2017
    Messages:
    45
    Likes Received:
    26
    After the bed cools, I typically keep a box cutter razor blade (just the rectangular blade) and gently work it under one side if round or a corner is squarish. I get it as far as I can and then use a putty knife to wedge under that and it pops off. If it's really suborn, I do multiple sides/corners. I take my time getting the razor blade under to not damage the part or bed.

    Scott
     
    tkoco and mark tomlinson like this.
  3. VigilantWookie

    VigilantWookie New Member

    Joined:
    Feb 6, 2020
    Messages:
    12
    Likes Received:
    0
    Thanks! Managed to get it off.
     

Share This Page