1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer printer is not going side to side

Discussion in 'Troubleshooting' started by mike2017, Apr 14, 2018.

  1. mike2017

    mike2017 New Member

    Joined:
    Sep 4, 2017
    Messages:
    17
    Likes Received:
    3
    i was printing the egg and the wires got hang up and now the printer will just go back and forth not side to side could have something got burnned up like a stepper?

    thanks for any help
     
    #1 mike2017, Apr 14, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    More likely the Z home/endstop switches/wires got yanked out of place and maybe the Y as well (not sure which direction you mean by "side to side" so I assume you mean X is all that works)
     
    #2 mark tomlinson, Apr 14, 2018
    Last edited: Apr 14, 2018
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Robo3D R1 +Plus Ramps Board (labeled).jpg

    Here are the connections on the RAMPS board in case you need to trace them all the way back to there
    You didn't say which printer so I assumed an R1+, but if it is an R1 then the board is different
     
    #3 mark tomlinson, Apr 14, 2018

Share This Page