1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Printer stops after printing raft use Simplify3d

Discussion in 'Troubleshooting' started by Bob Hewston, Jan 23, 2015.

Thread Status:
Not open for further replies.
  1. Bob Hewston

    Bob Hewston New Member

    Joined:
    Jan 23, 2015
    Messages:
    3
    Likes Received:
    0
    Hey guys, I'm having issues with printing a file that I downloaded on thingiverse. I've included the link. http://www.thingiverse.com/thing:219362 Its a XXL smart controller case. The problem I'm having is when the raft has printed, the printer stops. the software I'm using is Simplify3d with standard settings. I've cleaned up the file using Netfabb and exported as a stl file. I've tried everything, any help would be appreciated.

    Thanks

    Bob
     
    #1 Bob Hewston, Jan 23, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    the preview looks correct? Do you get any errors in the control panel?

    Have you contacted simplify3d support?

    If you load the gcode in Repetier does anything look weird?
     
    #2 Mike Kelly, Jan 23, 2015
  3. Bob Hewston

    Bob Hewston New Member

    Joined:
    Jan 23, 2015
    Messages:
    3
    Likes Received:
    0
    I solved the issue. It was the power settings on my MacBook. The usb timed on my computer timed out. Thanks for you help Mike.
     
    #3 Bob Hewston, Jan 23, 2015
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    There are a lot of repair tools in Simplify now as well.
    You might want to go through their tutorials.
     
    #4 mark tomlinson, Jan 24, 2015
Thread Status:
Not open for further replies.

Share This Page