1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Printer won't extrude after it runs for a few minutes

Discussion in 'Troubleshooting' started by Rick Rietow, Jan 16, 2017.

Thread Status:
Not open for further replies.
  1. Rick Rietow

    Rick Rietow New Member

    Joined:
    Apr 26, 2016
    Messages:
    16
    Likes Received:
    2
    I need some help. I have the weirdest thing happening. I've tuned in my Z lift so I get a great bead on the test print. when I print something I get a great outline and primary line but after it runs for a while the filament stops coming out. I pull the filament out and it is rubbed down when the extruder attempted to push the filament out. I've replaced the nozzle, heater, heat sink and I tried several different filaments same result. Any ideas???
     
    #1 Rick Rietow, Jan 16, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Jan 16, 2017
    Geof likes this.
  3. Rick Rietow

    Rick Rietow New Member

    Joined:
    Apr 26, 2016
    Messages:
    16
    Likes Received:
    2
    The Oil did the trick Thanks for the idea.
     
    #3 Rick Rietow, Jan 18, 2017
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page