1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Printing with ASA

Discussion in 'Troubleshooting' started by grant, Feb 3, 2018.

  1. grant

    grant New Member

    Joined:
    Aug 7, 2017
    Messages:
    24
    Likes Received:
    3
    Has anyone had any luck printing with ASA on the r1 plus? I've been trying but mine keeps warping after half way through the print. I'm printing with 255 extruder at start, then down to about 245-250. and 110 bed. 20 percent fan.

    any help would be appreciated! I'm trying to use a filament that can be left in the car all year long.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    I have not used ASA, but BluPrint works wonderfully in high temp environments.

    Someone who has used ASA can chime in (@Geof maybe?)
     
  3. grant

    grant New Member

    Joined:
    Aug 7, 2017
    Messages:
    24
    Likes Received:
    3
    I'll have to look into blueprint, don't think I've ever heard of it.
     
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I've printed with ASA but not on the R1+, it takes about 105 on the bed on most my machines to keep from warping. Can try some buildtak as it sticks very well to that... Almost to well
     
  5. grant

    grant New Member

    Joined:
    Aug 7, 2017
    Messages:
    24
    Likes Received:
    3
    I'll try 105. So far I've done 90 since I've seen people have good success with that, also tried 115 but still warped.
     

Share This Page