1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Prints to high and this...

Discussion in 'Troubleshooting' started by Mobilegroomer, Jan 29, 2021.

  1. Mobilegroomer

    Mobilegroomer New Member

    Joined:
    Jan 29, 2021
    Messages:
    2
    Likes Received:
    1
    Don't think my vid will link, but here's my problem. My 3dR1+ has started printing too high. Don't have that on video but I do have this. This is what happens when I select "auto home". Notice at the end of the video the extruder goes up. Every time I select auto home it goes higher. Oh, and I'm a noob who really knows very little about what I got myself in to.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    That symptom means that one of your Z home switches (there are 2 on an R1+) is not working correctly. It is either not seated right or has gotten turned around in the mount OR one of the wires has gotten loose. Easy fix once you see which one is causing the problem.

    Watch this and see how it should be:





    In rare cases it could be a fault with the RAMPS board, but that is unlikely.
     
  3. Mobilegroomer

    Mobilegroomer New Member

    Joined:
    Jan 29, 2021
    Messages:
    2
    Likes Received:
    1
    Thank you!! You were right and I have it working now. Just minor issue now and I'll post again if I can't figure it out. Thanks again.
     
    mark tomlinson likes this.
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338

Share This Page