Prints with new R1 +plus

So far I'm liking the new R1 +plus printer and the updated Matter Control software. Last summer I tried to print this musician I scanned in, and couldn't get the guitar to print. Now it prints . . . . well almost acceptable.



This is a lady I scanned in yesterday with the Sense hand held scanner and printed last night.

 

Looks nice, scans tend to be really tricky to print

 

Scan and print of my daughter and her boyfriend

 

This one I added a tan spray paint over the white plastic. (three people scanned at different times put together in tinkercad.)

 

Do yu mind sending me your matter control settings?

 

For the most part I have the default settings. The only one's I've changed are these:

Fill material I've set at 20%
I've checked both boxes on repair

I don't use support material unless I absolutely have to then these setting:
Lines
10 degrees

When I use the XT filament from color fab I also change the bed to 70c and the head to 250 for the layers until it starts doing the fill material, then I turn it down to 245.

I print on medium quality (I haven't had much luck with the high quality prints of the portraits.)

Scanner I use is the Sense Handheld scanner, then I use Tinkercad to resize and make sure the bottom is on the print bed (sense program has a nasty habit of putting it a few mm's off the print bed)

 

So I had a guy call and ask if I could do a portrait of his son with his bike. My standard answer is "I haven't tried that yet . . . but it should work." Learned that bikes are hard to scan! Have a little clean up to do from the fill material but not bad.

 

One day I'll try to print the 3d scan of me (My current profile pic) taken at Mini-Maker Fair: Denver