1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer Problem when prints get "high"

Discussion in 'Troubleshooting' started by Skivholme, Feb 26, 2018.

  1. Skivholme

    Skivholme New Member

    Joined:
    Dec 30, 2014
    Messages:
    13
    Likes Received:
    2
    Hi,

    I have a problem when printing high object, as you can see on the attached picture the print gets "blurry", this when the print reach a hight of about 5cm.

    Printer: R1
    Bed makeup: none,
    Fillment: PLA
    Extruder Temperature: 187c
    Bed Temp: 70c

    20180226_113459.jpg
     
    #1 Skivholme, Feb 26, 2018
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    General causes, in no particular order
    1. no support, tall and or thin elements tend to get pushed around by the next layer extruding.
    2. printing too fast, vibrations will move thin and or tall model elements around while the bed moves back and forth.
    3. printing too hot, small model elements won't have time to cool properly when the next layer is applied.
     
    #2 WheresWaldo, Feb 26, 2018
    Lee. A and Geof like this.

Share This Page