1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Problems with print

Discussion in 'Troubleshooting' started by Helen, Oct 11, 2017.

  1. Helen

    Helen New Member

    Joined:
    Oct 10, 2017
    Messages:
    2
    Likes Received:
    1
    Can any one help. My pla is stopping feeding through from the roll mid print. It has plenty on the reel so should not be an issue. When this happens robo continues to print but then causes the top to go stringy etc.

    Can anyone help please.
     
    #1 Helen, Oct 11, 2017
    Geof likes this.
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Hi @Helen sounds like a jam. There are a few things you can do. One is add an oiler. You also want to check to ensure the gears on your Robo are turning and not stopped. The 3rd thing you want to look at is the springs that apply tension. Tighten them up a big and see if that helps.
     
    #2 Geof, Oct 11, 2017

Share This Page