1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered R1+ help

Discussion in 'Troubleshooting' started by Joshua S., Oct 16, 2020.

  1. Joshua S.

    Joshua S. New Member

    Joined:
    Oct 2, 2020
    Messages:
    1
    Likes Received:
    0
    Hello everyone,

    I recently ran into an interesting issue with my Robo 3d r one plus+. When the printer would zero on command from me, it worked fine. However, when I tried to do a print the bed would lock and not move. I inspected the printer and found that the cable from the bed to the printer (the ribbon cable) seemed compromised. Essentially, one of the pins was half as tall as the others. Any ideas on how to fix this? The only solution I can seem to find is to buy a whole new print bed, which I would rather avoid if I can.
     
    #1 Joshua S., Oct 16, 2020
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Post a picture somewhere (you probably can't post one here -- use imagur or flickr or some other service) and post a link to the picture of the cable and connector you are talking about. I can't see needing a new cable, it should be repairable.
     
    #2 mark tomlinson, Oct 16, 2020

Share This Page