1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

R1+ support numbers

Discussion in 'General Questions' started by Stephen Jolly, Sep 14, 2018.

  1. Stephen Jolly

    Stephen Jolly New Member

    Joined:
    Jan 25, 2018
    Messages:
    5
    Likes Received:
    5
    I'm having a problem with support that is stuck to the build, I have be trying to find the right numbers that will make it easier to remove support, I'm using Matter Control with the R1+, if anyone has an answer please let me know
     
    #1 Stephen Jolly, Sep 14, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Good luck, someone on here that uses MatterControl can perhaps chime in.

    MatterCOntrol has their own specific forum if you would like to try there.
     
    #2 mark tomlinson, Sep 14, 2018
  3. Stephen Jolly

    Stephen Jolly New Member

    Joined:
    Jan 25, 2018
    Messages:
    5
    Likes Received:
    5
    Thank you
     
    #3 Stephen Jolly, Sep 14, 2018
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Good luck :)
    I see you posted over there as well -- someone should be able to chime in.

    If not, try another slicer.
     
    #4 mark tomlinson, Sep 15, 2018

Share This Page