1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

R2 Stylus Holder

Discussion in 'Show and Tell' started by Ed Ferguson, Jun 16, 2017.

  1. Ed Ferguson

    Ed Ferguson Active Member

    Joined:
    Sep 21, 2016
    Messages:
    272
    Likes Received:
    220
    R2 Stylus Holder

    Pclabtech designed an LCD stylus holder that snaps over the Robo R2 metal door handle.

    https://www.thingiverse.com/thing:2381827

    Made mine with MakerGeeks silver PLA at 225 deg. 0.1mm layers. Sliced with Simplify3D.

    Thanks Pclabtech!

    Robo R2 Stylus Holder Thingiverse.jpg
     
  2. pclabtech

    pclabtech Active Member

    Joined:
    Feb 20, 2013
    Messages:
    111
    Likes Received:
    73
    That looks nice! I need to do one in matching colored plastic instead of the brown that I had loaded, but... I "semi blame" this print job for the scars and bruised ribs I received from my car running over me. I was running on 2 1/2 hours of sleep after finishing it and posting it on Thingiverse that when I got up in the morning to go to work, I dropped my sunglasses on the floor of the car and forgot I had put it in reverse... To make a long story short, the open car door bitch slapped me to the ground and left me unconscious.
     
  3. Pilsnerboy

    Pilsnerboy New Member

    Joined:
    Jun 9, 2017
    Messages:
    19
    Likes Received:
    2
    Looks good. The clip looks stable and won't be easy to detach on its own. :)
     
  4. Todd Wessendorf

    Todd Wessendorf Active Member

    Joined:
    Feb 14, 2016
    Messages:
    125
    Likes Received:
    47
    And makes the door easier to open with the left hand, in my opinion. I didn't think I would ever use the stylus, but now that it is right there, I prefer it to my fat fingers that are hit-and-miss on the screen.

    Nice design, pclabtech!
     
    pclabtech likes this.

Share This Page