1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

R2 X AXIS

Discussion in 'Troubleshooting' started by bill Snyder, Mar 28, 2019.

  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,141
    Likes Received:
    6,998
    Yea, measuring it would be the only way to be certain. I can get to the ones on the C2 if we ever need
     
    Geof likes this.
  2. bill Snyder

    bill Snyder Member

    Joined:
    May 8, 2018
    Messages:
    39
    Likes Received:
    11
    Thanks everyone. Ordered off amazon. it's 8mm id. 12mm od. it is a flanged bearing
     
    Geof and mark tomlinson like this.
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,806
    Likes Received:
    3,521
    MF128ZZ

    MF = Flanged
    128 = Size
    ZZ = how it is shielded (sealed)
     
    mark tomlinson likes this.
  4. bill Snyder

    bill Snyder Member

    Joined:
    May 8, 2018
    Messages:
    39
    Likes Received:
    11
    wow what a project this has been. First stepper motor went out. Then while replacing with a Robo supplied stepper (in warrantee ) lost end bearing. Thanks for replacements on amazon (also got 4 from robo) and was up and running. Came back in the room a little later to find whole hot end on glass still extruding. So looking in this forum found replacement. Put new hotted in. Used same heater but themister replaced. Keeps on temp even better. Printing like it did out of box almost a year ago. Thanks everyone for help. Will upload images soon.
     
    Geof and mark tomlinson like this.

Share This Page