1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Rearm

Discussion in 'General Questions' started by spankurmonkey, Feb 15, 2017.

  1. spankurmonkey

    spankurmonkey Member

    Joined:
    Dec 26, 2016
    Messages:
    102
    Likes Received:
    3
    #1 spankurmonkey, Feb 15, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    This will not help... that.

    If it will work it will be a faster board, but I sincerely doubt your prints are slower due to a slower board... I have one Robo with a volcano* that is pushing the steppers as fast as they can move... that is the limiting factor. Not the code telling them to move :)


    *more plastic faster -> faster prints by a LOT
     
    #2 mark tomlinson, Feb 15, 2017
    Geof likes this.
  3. daniel871

    daniel871 Well-Known Member

    Joined:
    Apr 18, 2015
    Messages:
    1,322
    Likes Received:
    510
    The only thing a 32-bit controller will get you is smoother calculations for complicated movements (this is why they're preferred on Delta printers), the actual movement speeds will be limited by the rigidity of the printer and the stepper motors/drivers.
     
    #3 daniel871, Feb 15, 2017
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Plus ReArm requires you to learn a different firmware. It runs Smoothieware not Marlin.
     
    #4 WheresWaldo, Feb 15, 2017
    mark tomlinson likes this.

Share This Page