1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Replace old limit switch for X axis

Discussion in 'General Questions' started by Charles M Waldie 3, Jan 5, 2017.

Thread Status:
Not open for further replies.
  1. Charles M Waldie 3

    Charles M Waldie 3 New Member

    Joined:
    Feb 13, 2016
    Messages:
    15
    Likes Received:
    2
    I am trying to find a replacement for my limit switch and wires for my Robo3d R1. The limit switch is bad and wires look old. Trying to find a replacement and my search is null. I keep seeing these new type of limit switches, but they use three pin instead of the two pin robo 3d R1 uses on the Ramps 1.4 board.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Charles M Waldie 3 likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    The two pins they show connected are the two to use

    Sent from my SAMSUNG-SM-G930A using Tapatalk
     
    Charles M Waldie 3 likes this.
  4. Charles M Waldie 3

    Charles M Waldie 3 New Member

    Joined:
    Feb 13, 2016
    Messages:
    15
    Likes Received:
    2
    Thanks man I appreciate it.
     
Thread Status:
Not open for further replies.

Share This Page