1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Replacing Belt

Discussion in 'Troubleshooting' started by Steve pointon, Sep 9, 2018.

  1. Steve pointon

    Steve pointon New Member

    Joined:
    May 18, 2013
    Messages:
    12
    Likes Received:
    0
    My y axis short belt has become sloppy where can i get a replacement?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    On the R2?
     
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    605/606 mm endless loop from my recollection
     
    Geof likes this.
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Typically if a belt goes sloppy its because your gantry isn't square. I run the daylights out of my R2 and unless a pulley moves those belts stay tight (its very odd in this style printer - ultimaker, sigma etc) to have an issue where the belt needs played with tension wise or replaced.
     
    mark tomlinson likes this.

Share This Page