1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Robo offers finished print very slowly

Discussion in 'Troubleshooting' started by Curtis Wolfe, Mar 7, 2017.

Thread Status:
Not open for further replies.
  1. Curtis Wolfe

    Curtis Wolfe Active Member

    Joined:
    Feb 21, 2017
    Messages:
    254
    Likes Received:
    78
    We've had our Robo 3D a little over a week now and been printing like crazy. I would say probably 45 hours on it. We're very happy with it. I'm learning Matter Slice more and more each day and reading about G coding. We are having some vibrations causing some Y axis shifting. I may need to go through and tighten stuff up. Especially because last night I was pulling a print that was welded to the bed and the bed shifted.

    My question here is today it started offering finished prints very slowly. This used to be pretty quick as the extruder slid over to its finished postion and the bed slid forward. Now that process is very slow.

    Wonder why that changed? It wasnt doing it earlier today. Reboot and restart perhaps?

    Curtis
     
  2. Curtis Wolfe

    Curtis Wolfe Active Member

    Joined:
    Feb 21, 2017
    Messages:
    254
    Likes Received:
    78
    A reboot resolved the issue.
     
    m4r1n5, Geof and mark tomlinson like this.
  3. m4r1n5

    m4r1n5 Member

    Joined:
    Mar 31, 2016
    Messages:
    98
    Likes Received:
    26
    I tell that to everybody with a computer problem

    Sent from my LG-H830 using Tapatalk
     
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page