1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Robo R1+ Temp fell too much

Discussion in 'Troubleshooting' started by Victoria Nedbal, Sep 21, 2018.

  1. Victoria Nedbal

    Victoria Nedbal Member

    Joined:
    Sep 21, 2018
    Messages:
    33
    Likes Received:
    4
    Hello all,

    One of the Robo R1+ I work with failed and disconnected itself due to the following error

    upload_2018-9-21_13-25-39.png

    I've researched this and some people say its because of the thermistor being loose and whatnot. However this error only occurs when I print stuff overnight. The printer works fine during the day. Any idea what the problem could be?
     
    #1 Victoria Nedbal, Sep 21, 2018
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    interesting. if you are printing and wiggle the wiring can you mimmick the issue?

    Temp fall is usually either the thermistor or the part cooling fan is cooling the hotend to quickly and it cant keep it (temp falls to much and the firmware kicks the error)

    if its the thermistor it could be loose or bad wiring (wiggle test for wiring to start)
     
    #2 Geof, Sep 21, 2018
    mark tomlinson likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #3 mark tomlinson, Sep 26, 2018

Share This Page