1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Robo Sample PLA

Discussion in 'Filament' started by WheresWaldo, Nov 9, 2017.

  1. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Not my favorite and have to print it hotter than any other PLA I have used but I have been trying to use up the roll.
     
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Pencil cup
    [​IMG]

    Prototype clamp
    [​IMG]

    One half of a paper towel holder
    [​IMG]

    Clamp prototype that still doesn't fit exactly right
    [​IMG]


    Sent from my SAMSUNG-SM-N910A using Tapatalk
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    For that being the (infamous) sample filament, that is actually very good -- bordering on excellent.
     
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    First one printed in Vase mode.

    Too fast on the holder so where it changes from a flat section to include the cup and mounting plane there appears to be a shift line. 70 mm/s.
     
  5. Kilrah

    Kilrah Well-Known Member

    Joined:
    Apr 18, 2017
    Messages:
    498
    Likes Received:
    332
    It's worked perfectly fine for me... after I rewound the spool that would otherwise tangle every 30 minutes.
     
    Geof likes this.

Share This Page