1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved (Robo3D R1) Extruder Not heating Past 192~ C

Discussion in 'Troubleshooting' started by DomPruss, Jan 12, 2017.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Well assuming a new/good thermmistor the next part that could be bad is the RAMPS board itself.
    I would sanity check the wiring from the RAMPS to the thermistor first.
     
    #21 mark tomlinson, Jan 16, 2017
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Are you sure the thermistor isn't plugged into the fan connector, they are identical after all.
     
    #22 WheresWaldo, Jan 16, 2017
    mark tomlinson likes this.
  3. DomPruss

    DomPruss New Member

    Joined:
    Jan 12, 2017
    Messages:
    6
    Likes Received:
    3
    Well now I feel like a silly idiot. This was definitely a problem! Checked with the first Thermister, and was still getting weird readings. The new thermister is working amazingly well, and is now plugged in correctly!

    Thank you all very much!
     
    #23 DomPruss, Jan 16, 2017
    Rigmarol and mark tomlinson like this.
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    They chose not to use a unique plug or plug color -- easy mistake to make.
     
    #24 mark tomlinson, Jan 16, 2017
    Rigmarol likes this.
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page