1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered S3D question: Y axis...

Discussion in 'General Questions' started by GAmbrosio, Apr 6, 2016.

  1. GAmbrosio

    GAmbrosio Active Member

    Joined:
    Feb 22, 2016
    Messages:
    238
    Likes Received:
    79
    I noticed that using the default Robo R1 profile in S3D, the flipp the Y axis box is enabled. I initially ignored it thinking the S3D folks at this point know my printer better than I do, however when I hit the jog controls expecting the bed to come me, it went way back causing the nasty grating of the stopper motors pushing itself to the limits.

    The question, would I totally screw it up if I change the settings so that the Y axis is "normal?"


    Sent from my iPhone using Tapatalk
     
    #1 GAmbrosio, Apr 6, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    try it with a small test model.
    How bad could it be :)
     
    #2 mark tomlinson, Apr 6, 2016
    Geof and GAmbrosio like this.
  3. GAmbrosio

    GAmbrosio Active Member

    Joined:
    Feb 22, 2016
    Messages:
    238
    Likes Received:
    79
    Lol with my luck something crazy will happen that will cause the bed to shoot out and imbed itself to a wall. :)


    Sent from my iPhone using Tapatalk
     
    #3 GAmbrosio, Apr 6, 2016
    Geof likes this.
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Lol now that would be impressive!
     
    #4 Geof, Apr 9, 2016
    GAmbrosio likes this.

Share This Page