1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

SaintSmart TPU infill issues

Discussion in 'Printing Filament' started by rn_1604, May 6, 2016.

  1. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Good job! Might try 20mm/s if it doesnt clean up
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Support is very difficult with the flexible filaments. Small pillars that would work with normal stuff will fail hard with the flexible ones. you need to get creative with how you cad them in.
     
    Geof likes this.

Share This Page