1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Set to turn off bed heat after print?

Discussion in 'General Questions' started by Wesley Knapp, Feb 18, 2019.

  1. Wesley Knapp

    Wesley Knapp Active Member

    Joined:
    Jan 19, 2019
    Messages:
    111
    Likes Received:
    42
    I often start a print before hitting the hay for the night. I'd like to have the bed heat turn off when a print is complete rather than running it all night. On the LCD and in MC it shows setting at 0° yet it's hot and temp reading on LCD and in MC shows heat is still on.



    Sent from my Pixel XL using Tapatalk
     
    #1 Wesley Knapp, Feb 18, 2019
    Last edited: Feb 18, 2019
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Add the command to the ending GCode block for the slicer you use to force a shutdown of the heaters:

    M104 S0 ; make sure the extuder is turned off.
    M140 S0 ; make sure the bed is turned off.
    M84 ; shut down motors.
     
    #2 mark tomlinson, Feb 18, 2019
  3. Wesley Knapp

    Wesley Knapp Active Member

    Joined:
    Jan 19, 2019
    Messages:
    111
    Likes Received:
    42
    Cool. It wasn't there but is now. Thanks much!

    Sent via PixelXL3 using Tapatalk.
     
    #3 Wesley Knapp, Feb 18, 2019
    mark tomlinson likes this.

Share This Page