1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Skeinforge

Discussion in 'Software' started by mark tomlinson, Nov 30, 2013.

  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Does anyone who uses this care to share a configuration file?

    I know I saw this in another thread, but nobody volunteered.
    There are a lot of 'knobs' and 'switches' in there :) not sure which ones to tweak.

    I have a few models that I routinely have Slic3r fail on and sometimes Cura will work, but the ability to control support material in Cura is, well, sad...and it tends to generate fairly robust support material (which is a PITA to remove). Today I worked around it by messing with kisslicer and after several tweaking iterations was able to import that gcode and get a print going that should work. I think Skeinforge would also work, but my attempts to sift through configuring it have been fraught with failure.

    Anyway, if someone would be willing to share a Skeinforge configuration settings file that works... I would appreciate it.
     

Share This Page