1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Stopped printing mid print

Discussion in 'Troubleshooting' started by TKCC71, Apr 4, 2017.

  1. TKCC71

    TKCC71 Member

    Joined:
    Mar 24, 2016
    Messages:
    75
    Likes Received:
    31
    trying to figure out what's happening and was wondering where I should start. I currently have the E3D v6 and my printer all of a sudden stop printing about 4 hours into the print. The extruder actually stopped on the print. At first I thought The might of been a power outage but not the case. I removed the part and tried to reprint again. The printer started the level check and then froze? I went into simplify 3D and check the temps and noticed the bed temp goes up but the extruders not budging. I checked for loose wires and don't see anything. The small fan is working fine. Where should I start troubleshooting?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    You should have looked back through the GCode terminal for any errors. Do that now when trying to talk to it and see what it is reporting back.
     

Share This Page