1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Temp Fail Error

Discussion in 'Troubleshooting' started by gayoub, Mar 20, 2019.

Thread Status:
Not open for further replies.
  1. gayoub

    gayoub Member

    Joined:
    Sep 18, 2015
    Messages:
    47
    Likes Received:
    13
    Hi Guys
    I have a Robo3dR1 with the v6 hotend. It's been working fine for ages, but today for some reason, I keep getting a Temp Fail Error and the job stops immediately.
    I have tried it with USB or on Card, with the same result.
    Can someone give me a step by step help as to how I find the solution.
    Thanks in advance.
    George
     
    #1 gayoub, Mar 20, 2019
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Mar 20, 2019
  3. gayoub

    gayoub Member

    Joined:
    Sep 18, 2015
    Messages:
    47
    Likes Received:
    13
    Thanks guys
    I checked the wiring for the thermistor and heater core and it seems that something was loose. It printed fine after than. I will keep an eye on those two, just in case. Thanks for your quick help.
    George
     
    #3 gayoub, Mar 20, 2019
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page