1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Test Print very loose

Discussion in 'Troubleshooting' started by becca3940, May 8, 2019.

  1. becca3940

    becca3940 New Member

    Joined:
    Dec 6, 2017
    Messages:
    5
    Likes Received:
    0
    I can't figure out why this test print that came on the Robo R2 is not working. I quit trying to use ABS filament and am now having this issue with PLA. I had to put tape down to even get it to semi stick and it is all loose like this. Any suggestions would be most appreciated. Thanks
     

    Attached Files:

    #1 becca3940, May 8, 2019
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, May 8, 2019

Share This Page