1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

The printer is not recognizing the USB.

Discussion in 'The Printer' started by Jose Luis Abad, Feb 9, 2022.

?

Does your 3d Printer allow you to use USBs/Hard Drives?

  1. Yes

    0 vote(s)
    0.0%

  2. No

    1 vote(s)
    100.0%

  3. Working on it

    0 vote(s)
    0.0%
  1. Jose Luis Abad

    Jose Luis Abad New Member

    Joined:
    Feb 9, 2022
    Messages:
    1
    Likes Received:
    0
    Hello,
    I have tried using my USB/Hard Drive on my Robo e3 and it says "USB not recognized" "Please try again later". I tried a few hours later and still didn't work. I was wondering if it's a problem with the 3d printer or if it's just a problem with the USB. ​
     
    #1 Jose Luis Abad, Feb 9, 2022
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    24,007
    Likes Received:
    7,346
    Posted in wrong area -- moving to E3 forum
     
    #2 mark tomlinson, Feb 11, 2022
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    24,007
    Likes Received:
    7,346
    The R2/C2 can do this because they have a Raspberry Pi internally with Linux (which supports mounting external drives).
    The R1/R1+ and likely the E3 do not have Pi internally and the internal control boards do not have an operating sytem.

    I am not certain on the E3 since I never saw one, but @Geof can probably answer that more definitively
     
    #3 mark tomlinson, Feb 11, 2022

Share This Page