1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Thermistor wire broke at connector

Discussion in 'Troubleshooting' started by John in MS, May 13, 2018.

  1. John in MS

    John in MS Active Member

    Joined:
    Oct 26, 2015
    Messages:
    188
    Likes Received:
    29
    The wire that connects the thermistor to the ramps broke at the connector. Can this be bought at Amazon or must it come from Robo?

    Its a stock Robo r1 plus
     
    #1 John in MS, May 13, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    If it broke where it connects to the RAMPS is it an Amazon part I think. The quick-disconnect down near the hotend might be a Robo part (I am sure it can be bought elsewhere -- I do not have one to look at). Perhaps @Geof or @WheresWaldo can comment. Neither of my R1 series have that disconnect in-line.
     
    #2 mark tomlinson, May 13, 2018
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    That disconnect was a JST-SM 2 conductor connector, You can get it prewired or just the crimps and housing. Amazon has it pre-wired, Digikey and Mouser have it as crimp connectors and housing.

    [​IMG]

    [​IMG]
     
    #3 WheresWaldo, May 13, 2018
    mark tomlinson and Geof like this.
  4. John in MS

    John in MS Active Member

    Joined:
    Oct 26, 2015
    Messages:
    188
    Likes Received:
    29
    [​IMG]
    This is the wire in question. We have a local electronics wholesale place i might check along with Amazon
     
    #4 John in MS, May 13, 2018

Share This Page