1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Trying to Rewire to make generic Ramps Work

Discussion in 'Troubleshooting' started by izumi5188, Sep 23, 2017.

Thread Status:
Not open for further replies.
  1. izumi5188

    izumi5188 Member

    Joined:
    Feb 12, 2017
    Messages:
    59
    Likes Received:
    20
    My bed heater stopped functioning. Based upon other peoples thread
    I tried following this thread: http://community.robo3d.com/index.p...and-rewiring-to-make-generic-ramps-work.8356/ and I get figure out what I missed.

    My fan powers up, my lights turn on. However my LCD screen and my arduino don't seem to be powering up.
    What is also concerning is my MOSFET get extremely hot upon turning it on, and thus so does the bed. Not sure where to start.

    Any suggestions?
     
  2. izumi5188

    izumi5188 Member

    Joined:
    Feb 12, 2017
    Messages:
    59
    Likes Received:
    20
    Well, pulling my power wires, one was really lose. They seem to light up now. Arg. Off course I see the issue after I open the thread.
     
    Geof and mark tomlinson like this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    If I had a dollar for every time I opened a thread and then figured it out :D. Those wires are very tricky, glad you got it sorted. If you have further issues with your conversion PM me or ping me on your thread and I'll do my best to respond quickly.
     
Thread Status:
Not open for further replies.

Share This Page