1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Two different impressions in one PC

Discussion in 'General Questions' started by Bernyboy, Feb 8, 2019.

  1. Bernyboy

    Bernyboy New Member

    Joined:
    Feb 8, 2019
    Messages:
    1
    Likes Received:
    0
    I have 2 printers (ROBO 3D +) and I would like to know how I can print in both machines using only one computer connected to both. My trouble is that when I want to use the printers on the same time (trying to print 2 different figures), the first impression that I did is canceled due to the new impression done after it, so I would like to know if I can do impressions simultaneously or not without affecting the queue.

    Greetings.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    You either run two host programs (like MatterControl) or have one that will support multiple printers.
    Or, the best way, is to use OctoPi or an LCD controller to do the printing and your PC can be disconnected from the printers.
    Run as many as you want from one PC (I run 6)
     
    Wesley Knapp and Bernyboy like this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Bernyboy likes this.

Share This Page