1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Very bumpy prints?

Discussion in 'Troubleshooting' started by Steviejeevie, Mar 22, 2017.

  1. Steviejeevie

    Steviejeevie New Member

    Joined:
    Mar 22, 2017
    Messages:
    3
    Likes Received:
    0
    Is this normal for a .2 mm quality print? If not what could be causing it? It only appears on rounded objects, if I do a square or something similar it's smooth
     

    Attached Files:

  2. Steviejeevie

    Steviejeevie New Member

    Joined:
    Mar 22, 2017
    Messages:
    3
    Likes Received:
    0
    Extruder is at 210 bed is at 50 printing with stock hot and and 1.75 pla, also has dual fan mod on carriage
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Probably over extrusion. Have you calibrated the extruder?

     
  4. Steviejeevie

    Steviejeevie New Member

    Joined:
    Mar 22, 2017
    Messages:
    3
    Likes Received:
    0
    Ok I'll try this first, I started with the simplify 3d troubleshooting stuff and messing with different values but I have a feeling the calibration will help
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    If you are over extruding the filament has to go somewhere and if you are under extruding you will have gaps. Hard to say which that might be

    Sent from my BNTV450 using Tapatalk
     

Share This Page