1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

What are the exact steps to turn off autoleving in R2?

Discussion in 'General Questions' started by supercazzola, Oct 10, 2020.

  1. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    388
    Likes Received:
    102
    Can someone post the steps or point me to them?
    Again, I want to turn off autoleving in the R2 for good.
    thank you
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,713
    Likes Received:
    2,320
    Remove the g36/g29 depending on your start up scripts in your slicer and in octoprint. That’s it.
     
  3. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    388
    Likes Received:
    102
    Thanks Geof.
    I remember there was a time when we replaced G36 with G29. So leaving G28 there, and removing G29 is what I will now do. I appreciate your help as always.

    Kevin


    Sent from my iPad using Tapatalk Pro
     
    Geof and mark tomlinson like this.
  4. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    676
    Likes Received:
    258
    Always leave in the G28 command so that the hot-end always starts from a known position. Makes for repeatability while printing.
     
    supercazzola likes this.

Share This Page