Solved What glue to use

For the magnets to the glass?

Also is there supposed to be two one in the hole and one glued to the glass?

I bought some magnets from robo3d when I ordered another part.

Right now I got one magnet left and using rubber bands to hold the glass in place. I thought I might as well fix it.

 

Yes, two magnets for each contact point. One for the glass and one for the hole. Important to glue them with the correct polarity. So watch out for that. What glue to use? Good question. Let me check.

 

From @Mike Kelly , "CA glue or two part epoxy is good for gluing the magnets to the bed/plastic. I used 2 part plastic epoxy."

http://www.thingiverse.com/thing:681894

So that has to be good.

 

Funny that there are actually 6 contact points available, but mine just has the 4 corners. Not sure if adding the 2 middle ones would help anything or not.

 

Thanks will give it a try. Mine was refurbished so I wasn't sure of the proper config.

PS I doubt that all 6 are needed since I was doing fine with one magnet and rubber bands

 

Same. I have a refurb as well. Best deal if you ask me