1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved What is this?

Discussion in 'General Questions' started by Folk Hero, Jun 6, 2017.

  1. Folk Hero

    Folk Hero Member

    Joined:
    May 16, 2017
    Messages:
    34
    Likes Received:
    11
    When I print there is a single string silhouette of what I'm printing about ½" away from the print. It doesn't appear to be connected to anything. What is it and what is it called?

    Also should hairspray be applied after the bed warms up or when it's cold?
     
    #1 Folk Hero, Jun 6, 2017
    Last edited: Jun 6, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    A skirt
    Used to prime the nozzle
    Turn it off in the slicer if you want

    Sent from my SAMSUNG-SM-G930A using Tapatalk
     
    #2 mark tomlinson, Jun 6, 2017
    Geof likes this.
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    I spray cold then the heat from the bed dries it completely. But honestly it doesn't matter as long as you don't over do it.
     
    #3 WheresWaldo, Jun 6, 2017
    JennBarth and Geof like this.
  4. Folk Hero

    Folk Hero Member

    Joined:
    May 16, 2017
    Messages:
    34
    Likes Received:
    11
    Thanks that covered my questions.

    Tim
     
    #4 Folk Hero, Jun 7, 2017

Share This Page