1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Where is this from?

Discussion in 'Troubleshooting' started by Jutte, Jul 15, 2018.

  1. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    42
    Likes Received:
    19
    Better and better. What do you suppose this fell out of?
     

    Attached Files:

  2. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    42
    Likes Received:
    19
    Figured it out, every single one of the screws that level the bed fell out. How should I raise the bed to replace them?
     
  3. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    42
    Likes Received:
    19
    Got it. Under Motor Controls performed -Z until I could get at them all.
     
    supercazzola likes this.
  4. drbanks

    drbanks Active Member

    Joined:
    Dec 29, 2017
    Messages:
    141
    Likes Received:
    39
    Mine fall off all the time. I think as a result of all the shaking from printing. Kind of a bummer to have to re-level the bed.
     
  5. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,703
    Likes Received:
    2,313
    loc tite. Purple (low strength)
     
    Jutte likes this.

Share This Page