1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

wiring a new fan for the printer

Discussion in 'Mods and Upgrades' started by NKakon, Jul 26, 2017.

  1. NKakon

    NKakon New Member

    Joined:
    Nov 3, 2015
    Messages:
    18
    Likes Received:
    3
    Hey all,

    I just finished printing and installing a dual fan mount with shrouds for the R1, and I'm now realizing I overlooked the slight detail of wiring in the second fan...
    Is there a pin on the arduino board that's already set up for a second fan? or should I splice the second fan to the first one? Any other ideas for doing this?

    Thanks
     
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    mark tomlinson likes this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I did the same as @WheresWaldo Mine is a "Y connector" one to each fan into 1 for the harness. Works great. expecially if you have one fan die, you can pull it and replace without putting the machine down.
     

Share This Page