1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved X Axis not moving

Discussion in 'Troubleshooting' started by Tyler, Dec 24, 2017.

  1. Tyler

    Tyler New Member

    Joined:
    Dec 24, 2017
    Messages:
    2
    Likes Received:
    0
    When I try to print something it just prints a line along the y-axis, but the extruder does not move, but during the homing the extruder will move. Any advice?
     
    #1 Tyler, Dec 24, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Sounds sort-of like the start-up script for OctoPrint is running, but not nearly enough details there to tell you much more than that.
    How (exactly) are you try to print (and what is an example of something you are trying to print -- please be specific)
    What software are you slicing with ?
     
    #2 mark tomlinson, Dec 25, 2017
  3. Tyler

    Tyler New Member

    Joined:
    Dec 24, 2017
    Messages:
    2
    Likes Received:
    0
    I am using mattercontrol and I was trying to print the calibration circle. I am using PLA
     
    #3 Tyler, Dec 25, 2017
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    So how in mattercontrol are you trying to print? Are you saving the model and uploading it to OctoPrint and then launching the print or some other way? This is a C2 correct? That is the area you are posting in but want to be sure :)
     
    #4 mark tomlinson, Dec 25, 2017

Share This Page