1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved X axis Stepper issue

Discussion in 'Troubleshooting' started by 3DDP, Oct 31, 2016.

  1. 3DDP

    3DDP New Member

    Joined:
    Sep 18, 2016
    Messages:
    7
    Likes Received:
    0
    I've tested the driver, swapped the driver, swapped the board, and driver, swapped the cable, swapped the motor, and the stepper when on the carriage with the belt, seems to be locked up, and makes noise, and won't move. when powered it seems to stick, when power is removed it moves freely.... this is the case in each test scenario.

    Stepper voltage doesn't impact it, and even when I move the stepper to a different driver slot the same issue occurs, and the motor from the other axis works fine on the X axis.

    any thoughts?

    all I can think of is it's some alignment issue that forces the motor to get tweeted inside and brush up against the magnets incorrectly.
     

Share This Page