1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Y Axis Grind - Shifted Print

Discussion in 'Troubleshooting' started by spankurmonkey, Jan 18, 2017.

Thread Status:
Not open for further replies.
  1. spankurmonkey

    spankurmonkey Member

    Joined:
    Dec 26, 2016
    Messages:
    102
    Likes Received:
    3
    Y Axis is messed up not sure what to do.. may explain my shifted print from last night...
    Look at about 50 second mark you'll see what it does.


    [​IMG]

    Look at about 50 second mark you'll see what it does.
     
    #1 spankurmonkey, Jan 18, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Something is blocking the bed travel. Usually it is a cable loose and getting in the way.
     
    #2 mark tomlinson, Jan 18, 2017
  3. spankurmonkey

    spankurmonkey Member

    Joined:
    Dec 26, 2016
    Messages:
    102
    Likes Received:
    3
    I did check and it looked clear. but the cable was pinched in a slot at the back so I took it out of the slot and flattened it... going to try again.
     
    #3 spankurmonkey, Jan 18, 2017
  4. spankurmonkey

    spankurmonkey Member

    Joined:
    Dec 26, 2016
    Messages:
    102
    Likes Received:
    3
    This time it worked...... some how that cable must have shifted as I have not had any Y axis issue since I got it around christmas time.
     
    #4 spankurmonkey, Jan 18, 2017
    WheresWaldo and mark tomlinson like this.
Thread Status:
Not open for further replies.

Share This Page