1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Z Axis Problem

Discussion in 'Troubleshooting' started by Kmusial00, Jul 9, 2018.

  1. Kmusial00

    Kmusial00 New Member

    Joined:
    Jul 9, 2018
    Messages:
    1
    Likes Received:
    0
    Hey guys, I am new and this is my first 3D printer. So I just got my printer and i opened it and followed the instructions, wanted to print the calibration circle but my printer started printing in the air, so i stopped the print. I homed my X, Y, and Z Axis that's when i noticed that the left bolt that moves the nozzle in the z axis was working while the right bolt didn't move at all, so the nozzle tiled to a certain point and then returned to the original height. Does anyone know what might be the solution.

    Thanks
     
    #1 Kmusial00, Jul 9, 2018
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Make sure all the cables are plugged in, that is the first thing, you may have to pull off the bottom cover to see if the stepper (4 wires) is correctly plugged into the control board.
     
    #2 WheresWaldo, Jul 9, 2018
    Geof likes this.

Share This Page