1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Z-offset calibration card

Discussion in 'Troubleshooting' started by Studetrucknut, Jan 3, 2025.

  1. Studetrucknut

    Studetrucknut New Member

    Joined:
    Jan 3, 2025
    Messages:
    1
    Likes Received:
    0
    I just picked up a Robo R2 and it came without any tools or filament tube. I tried looking on the website for the Z offset card, but I didn't find one. What could I use as a substitute for calibrating the offset?
     
  2. BrooklynBay

    BrooklynBay Moderator
    Staff Member

    Joined:
    Apr 7, 2018
    Messages:
    497
    Likes Received:
    58
    This is the R1 section. Auto leveling should set the correct height.
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    24,018
    Likes Received:
    7,347
    Use a 3x5 index card or a sheet of paper. The exact size is not critical, you just want a small gap. I generally use a sheet of paper. You can always fine-tune the Z-offset in the EEPROM setting via the LCD if needed. A more - (negative number) is further from the bed so -1.1 is a larger gap than -1.0 (those numbers are just to illustrate the way it works, not actual good numbers)

    Moving this to the R2 section
     
    #3 mark tomlinson, Jan 6, 2025
    Last edited: Jan 6, 2025

Share This Page