1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by 3dinla

  1. 3dinla
    Post

    Answered Filament stuck in hotend

    Thank you! I ended up losing the piece further in, but I heated the end and pushed it through with a different piece of filament and I think I got...
    Post by: 3dinla, Dec 25, 2017 in forum: Troubleshooting
  2. 3dinla
    Thread

    Answered Filament stuck in hotend

    Not sure if this is a clog or a jam, but I have a length of filament stuck in my R1+ hot end. After reading a forum thread here on how to remove...
    Thread by: 3dinla, Dec 25, 2017, 2 replies, in forum: Troubleshooting
  3. 3dinla
    Post

    Solved Robo 3D R1 Z-Axis home is way off

    I just had to sort this out myself recently. The video is super helpful; definitely watch it. This attached picture shows one of my z-switches...
    Post by: 3dinla, Dec 7, 2017 in forum: Troubleshooting
  4. 3dinla
    Post

    Solved Nozzle does not move down

    The switch was indeed stuck open. I had to try a couple different things to get the piece that holds the bar to fit over the nut and rest against...
    Post by: 3dinla, Nov 26, 2017 in forum: Troubleshooting
  5. 3dinla
    Post

    Solved Nozzle does not move down

    Thanks for the pointer, I will give it a watch!
    Post by: 3dinla, Nov 23, 2017 in forum: Troubleshooting
  6. 3dinla
    Thread

    Solved Nozzle does not move down

    Hi there, Let me preface this by saying I am new to 3D printing and so a) I'm not sure how to search for the issue I'm having (z axis maybe?) and...
    Thread by: 3dinla, Nov 23, 2017, 4 replies, in forum: Troubleshooting