Recent Content by Andrew Kershaw

Post

Okay I tried 210 and it does extrude so maybe I should use this temp but that doesn't solve my issue of it not being able to print anything but...

Post by: Andrew Kershaw, Jul 11, 2018 in forum: Troubleshooting

Post

Yes, I have tried most of these options and found that 265C and a bed temp of 50C to work but now I got that working it's now being really weird....

Post by: Andrew Kershaw, Jul 11, 2018 in forum: Troubleshooting

Post

Yes, I do have the same issue at .2mm layer height. And that's what I thought bt the spool says 1.75mm and nozzle temp=245C and bed from 0-60C

Post by: Andrew Kershaw, Jul 9, 2018 in forum: Troubleshooting

Post

I'm using Raptor PLA which askes 245 C and a bed of 0-60 C so I keep my extrude at 245 and I keep my bed at 55. I know the temp isn't the issue...

Post by: Andrew Kershaw, Jul 9, 2018 in forum: Troubleshooting

Post

I don't know how to find that but my Layer Height is 0.1mm, with infill density with .25, also I was using Matter controls slicer what one should...

Post by: Andrew Kershaw, Jul 8, 2018 in forum: Troubleshooting

Post

It looks like it more sheards up the pla maybe because of retraction or something because everything I print and it fails from the PLA inside...

Post by: Andrew Kershaw, Jul 7, 2018 in forum: Troubleshooting

Post

It looks like to me that it can print the calibration box just fine but with anything else, it cramps up or something were the pla just doesn't...

Post by: Andrew Kershaw, Jul 7, 2018 in forum: Troubleshooting

Thread

So on my R1 Plus it starts to create a skirt and then after a raft but soon after it starts to go weird by spooing my raptor PLA out. But I think...

Thread by: Andrew Kershaw, Jul 6, 2018, 23 replies, in forum: Troubleshooting